The equipment is actually a lot cheaper if you’re a pro - the DIY pre-charged line-set adds about $500 over an equivalent unit. Pulling a vacuum and adding coolant is not hard, just requires specialized tools that still aren’t that expensive.
I mentioned warranty and insurance.
You don’t need to “schedule workers” if you are owner operating. Maybe you want a (non-skilled) helper to speed up the install, but you absolutely could install solo. That said, you will need a licensed electrician to run the circuit.
In my metro, hvac contractors can get ten-packs of permits for mini-split installs, and at most one out of ten is inspected. It’s a rubber stamp if you’re a pro, and the individual permit is maybe $50.
And that $5k I mentioned is the low bid, which you’ll only see if you know how to find contractors who aren’t private equity fronts. These guys are not advertising, but they stay busy by having the best price. There are shops that will happily charge you double for the same work.
I never said it’s a get rich quick scheme. It is just highly compensated for owners without requiring the level of expertise of something like a plumber or electrician. I’m curious what is happening in the market to support these margins.
Devils advocate here, it cost me ~$1500 in equipment to buy the vacuum pump, vacuum gauge, nitrogen air tank to flush the lines and pressure test, pressure manifold set and gauge, air lines, good flaring tool, copper bending tool, schrader valve pulling tools, various air tools, and a book on mini split installations.
Then it took me 2 days between pouring concrete pad for the heat pump, installing the heat pump and bolting it in, running the copper lines, drilling the exit hole, running the drain piping, learning how to use all the tools, running the electric and control cables and installing a new breaker and 220 subpanel, pressure testing, vacuum testing, flaring, releasing vacuum and all the stuff you have to do. I also had to spend several nights watching youtube and get a EPA 608 certification for handling refrigant which took another day.
Wouldn't have been worth it for a single unit, but was worth it for installing 3, and now I can do additional units for basically $0 overhead and of course no one would even have to know if I installed it and now I can order unlimited amount of refrigerants to my doorstep.
Having plumbed my entire house, and done my entire house electrical system, I would say the level of expertise to install a mini split is higher than either alone. You have to do electrical, plumbing, refrigerant handling, pressurized equipment handling, be liable for massive federal/EPA fines if you do something wrong, and on top of that I had to do masonry work.
There is a 0.00000% chance of getting into EPA trouble installing one minisplit. You got crews dumping 5 a day into a bucket of water all over and no one will answer a report
I mentioned warranty and insurance.
You don’t need to “schedule workers” if you are owner operating. Maybe you want a (non-skilled) helper to speed up the install, but you absolutely could install solo. That said, you will need a licensed electrician to run the circuit.
In my metro, hvac contractors can get ten-packs of permits for mini-split installs, and at most one out of ten is inspected. It’s a rubber stamp if you’re a pro, and the individual permit is maybe $50.
And that $5k I mentioned is the low bid, which you’ll only see if you know how to find contractors who aren’t private equity fronts. These guys are not advertising, but they stay busy by having the best price. There are shops that will happily charge you double for the same work.
I never said it’s a get rich quick scheme. It is just highly compensated for owners without requiring the level of expertise of something like a plumber or electrician. I’m curious what is happening in the market to support these margins.